CO Advice, Smart Home

Interlinking a FireAngel Pro Connected CO Alarm in to a Network

Including a CO detector into a network of Pro Connected alarms is simple, let Wes show you how – or follow the below instructions.

Using a ballpoint pen, briefly push and release the ‘learn button’ on the back of the CO detector.

The red LED next to the learn button will flash briefly then light up for approximately five seconds.

During these five seconds you need to briefly press the test button on an alarm that’s already prepared as per the instructions with the alarm (battery powered or mains powered). This secondary alarm will give an audible sound consisting of two cycles of four loud beeps.